The TD series is particularly suitable for the pneumatic conveyance of solid materials mixed with air, sawdust and woodchips; particulary suitable for fibrous materials that could clogg a backward type impeller of normal contruction.
The TD series has low capacities, high and medium pressures , statically and dynamically balanced steel impeller open blade. Fluid temperatures up to 60°C in standard execution; special executions for higher temperatures.
■ ATEX non-sparking version: shims on non-rotating parts potentially in contact with the fan in non-ferrous material.
■ Anticorrosive execution of paint choirs or special materials.
■ High temperatures with cooling fan up to 300 ° C, special executions on request for temperatures up to 450 ° C.
Direct coupling. Impeller mounted directly on the motor shaft. Flanged motor and fan without chair. Maximum operating temperature in standard execution: 60 ° C. In special execution: 150 °
Direct coupling. Impeller mounted directly on the electric motor shaft supported by the chair. Maximum operating temperature in standard execution: 60 ° C. In special execution: 150 ° C.
Belt coupling, cantilever impeller. Supports and motor mounted on a chair outside the air circuit. Maximum operating temperature in standard execution: 60 ° C. With cooling fan: 300 ° C.
Belt coupling, cantilever impeller. Supports mounted on chair, fan and motor mounted on the same base.Maximum operating temperature in standard execution: 60 ° C. With cooling fan: 300 ° C.
3) Suction Nozzle
4) Electric Motor B3 or B5
5) Motor supporting base
6) Outlet counter flange
7) Suction counter flange
8) Fan Support
9) Ring for felt sealing
11) Rubber gasket
12) Motor holding disk
13) Fan to dissipate heat
14) Grid for fan protection
15) Single-block support
18) Transmission guard
21) Motor slides
The standard production of fans with size 400 ÷ 630 provides an orientation with an angle of 30 ° instead of 45 °.
Requests with different angles must be made when ordering.